SRAM problem occurred./ SRAM was formatted.
There was an error in the SRAM.
Standard Tray is full. Remove the paper.
The standard output tray is full, or there is a problem with the paper tray motor. Remove the paper from
the tray.
Supply order has failed.
The automatic supply order failed. The message indicates the supplies that the printer tried to order.
The same IP Address exists on several interfaces. (###)
The same IP address has already been set on several interfaces. Contact the network administrator.
The same IPv4 Address already exists. (102/202)
The IPv4 address specified for the printer is already in use by another device on the network. Contact the
network administrator.
This NetBIOS name is already in use. (108/208)
The NetBIOS name specified for the printer is already in use by another device on the network. Contact
your network administrator.
(tray name) Error. Power Off/On./ Error recurs, call service.
There was an error with an input tray motor. Turn the power off, and then on again.
USB has a problem./ Please call service.
The printer has detected a USB board failure. Turn the power off, and then on again. If the problem persists,
contact your sales or service representative.
Values set for IPv6/Gateway addresses are invalid. (110/210)
The IPv6 address or gateway address is invalid. Check the network settings.
WPA Auth. incomplete. (211)
WPA authentication could not complete. Contact your network administrator.
Print/Data Errors (in alphabetical order)
Command Error.
A PCL command error occurred. Check the connection between the printer and the computer, make sure
you are using the correct driver for the printer, and make sure that the memory settings for the driver match
the memory installed in the printer.
Compressed Data Error
The printer detected corrupt compressed data. Check the connection between the computer and the printer.
Check that the program you used to compress the data is functioning correctly.
9. Troubleshooting
176
To Next Page
Loading...
