4. Lift the printer using the inset grips on both sides of the printer.
5. Align the holes over the pins, and then lower the printer gently onto the paper feed unit.
There are three pins on the top of the paper feed unit that point straight up. On the bottom of the
printer, there are three holes.
6. Attach the interface cable to the printer.
7. Plug the printer's power cord back into the wall outlet, and then turn on the power.
• After finishing installation, you can check whether the paper feed unit is properly installed: Print the
configuration page from the [List/Test Print] menu. If it is installed properly, you will see "Optional
Paper Feed Tray 2" or "Optional Paper Feed Tray 2, Optional Paper Feed Tray 3" for "Attached
Equipment" on the configuration page.
• If the paper feed unit is not installed properly, reinstall it from the start. If you cannot install it properly
even after attempting reinstallation, contact your sales or service representative.
• To attach two paper feed units at the same time, first stack them one upon the other, and then attach
them as a single unit.
• "Test Printing", Quick Installation Guide.
• p.96 "Loading Paper"
2. Installing Options
30
To Next Page
Loading...
