4. Insert the SD card into the slot until it clicks.
Insert the SD card in the appropriate slot as follows:
• Upper slot: Data overwrite security unit
• Lower slot: VM card
5. Reattach the cover over the optional card. Fasten the screw to secure the cover.
• Do not touch the card while the printer is in use. It may come loose, even if pushed only slightly. The
slot cover must be reattached.
• Confirm that the card was correctly installed by printing the configuration page.
• If the card is not installed properly, repeat the procedure from the beginning. If it cannot be installed
correctly even after reattempting installation, contact your sales or service representative.
• For details about printing the configuration page, see "Test Printing", Quick Installation Guide.
Installing SD Memory Card Options
51
To Next Page
Loading...
