5. Lower the rear cover until it is horizontal, and then pull it away.
6. Place the power cable inside the slot on the side of the duplex unit, and then push the duplex
unit along the rails in the back of the printer.
7. Push the duplex unit securely into the printer.
• After finishing installation, you can check whether the duplex unit is properly installed: Print the
configuration page from the [List/Test Print] menu. If it is installed properly, you will see "Duplex Unit"
for "Attached Equipment" on the configuration page.
• If the duplex unit is not installed properly, repeat the procedure from the start. If you cannot install it
properly even after reinstallation, contact your sales or service representative.
Attaching the Duplex Unit
53
To Next Page
Loading...
