11
Selection Of Spacer Ring Inserts And Upper
Spindle Washers
WARNING: Using the wrong spacer ring insert may
permit small pieces of wood or finger tips to
become wedged between the abrasive surface and
the insert.
• Use the smallest spacer ring insert that will fit over the
drum.
• Use the largest upper spindle washer that will not pro-
trude past sanding sleeve.
Sanding Sleeve
Diameter
Spacer Ring Insert
Opening Inside Diameter
Upper Spindle Washer
Outside Diameter
1/2 Inch
15/16 Inch 5/8"
3/4 Inch
1 Inch 1-3/16 Inch
7/8"
1-1/2 Inch 1-11/16 Inch
2 Inch 2-3/16 Inch 1-3/4"
Installing Sanding Sleeves for the 1/2"
Diameter Sanding Drum
WARNING: To reduce the risk of injury from acci-
dental starting, always turn switch “OFF”, unplug
the sander and remove switch key before removing
or replacing the spacer ring inserts, sleeves and
drums.
1. Remove the fan and clean sawdust from inside table
recess.
2. Slide the fan onto the shaft (vanes face down). The fan
is used with all sanding operations.
3. Install the table insert.
4. Use a straight edge as shown to make sure the table
insert is flush with the table
If necessary adjust the set screws in the table insert
with the 3/32 hex “L” wrench provided.
5. Position 1" inside diameter spacer ring insert in the
table recess.
6. Locate 1/2" sanding sleeve and slide it on the spindle.
(No drum is used.)
7. Install the upper spindle washer and tighten the knob.
Do not overtighten. NOTE: Knob turns counterclock-
wise to tighten.
8. Plug the power cord in the power source and install the
key.
Knob
5/8" O.D. Washer
1/2" Sanding
15/16" I.D. Spacer
Sleeve
Ring
To Next Page
Loading...
