22
Maintenance
WARNING: For your own safety, turn switch “OFF”
and remove plug from power source outlet before
adjusting or maintaining your sander.
WARNING: To reduce the risk of electrocution or
fire, any repairs to electrical systems should be
done only by qualified service technicians. Unit
must be reassembled exactly to factory specifica-
tions.
If power cord is worn or cut, or damaged in anyway, have
it replaced immediately.
Frequently blow out or vacuum out any dust that may
accumulate inside the motor.
Lubrication
All bearings in tool are self-lubricating. They require no
further lubrication.
RIDGID Recommends the Following Accessories
WARNING: Use only accessories recommended for
this sander. Using other accessories may be dan-
gerous.
Item SKU No.
Miter Gauge ....................................................... AC1021
Switch Key ......................................................... AC1000
Do not use any accessory unless you have received and
read complete instructions for its use.
Wiring Diagram
Motor
Ground
Screw
Black
Red
Relay
White
Switch
White
Black
Green
M
A
L
To Next Page
Loading...
