16
On-Off Switch
The On-Off switch has a locking feature. This Feature Is
Intended To Help Prevent Unauthorized And Possible
Hazardous Use By Children And Others.
1. To turn sander “ON” insert key into switch.
NOTE: Key is made of yellow plastic, located in loose
parts bag.
2. Insert finger under switch lever and Pull end of switch
out.
3. To turn sander “OFF”. Push lever in.
WARNING: Never leave the sander unattended until
it has come to a complete stop.
4. To lock switch in “OFF” position, hold switch “IN” with
one hand. Remove key with other hand.
WARNING: For your own safety, always lock the
switch “OFF” when sander is not in use. Remove
key and keep it in a safe place. Also, in the event of
a power failure (all of your lights go out) turn
switch off, remove the key and store it remote from
sander.
CAUTION: Before turning switch on, make sure the
belt or drum and sleeve are properly installed.
Getting to Know Your Spindle Sander (continued)
To Next Page
Loading...
