rigert Ltd., Stairlifts
Operating manual
Nr.: AW4231
CH-6405 Immensee
Fault finding PEGASUS-NOVA-mps2
Date: 13.03.06
Page: 5/22
Maintenance and repairs
Maintenance and repairs are the sole province of an authorised rigert Ltd., Stairlifts service engineer,
taking into consideration the safety regulations and instructions stated in this document.
Tools
Always use tools, original parts, materials and service techniques approved by the manufacturer.
Never use worn tools and put the tools away before doing a test run.
PC boards
The PC boards and the components on them represent electronic waste. Turn old PC boards in to
specialised companies for environmentally friendly processing.
Disposing of parts
Most parts of the stairlift are made of metal and can be disposed of in the regular manner as used metal. For
health and environmental reasons no asbestos has been used.
1 "Use according to purpose" as described in EN 292-1 is the use for which the product is technically suited, as specified by
the manufacturer and stated in the brochure of the manufacturer. In case of doubt this is the use that can be deduced from
the construction, the model and the function of the technical product, bearing in mind considerations of normal use. Use of
the stairlift within the limits of use according to purpose includes following the instructions contained in this document.
The stairlift shall be thoroughly examined at intervals not exceeding 12 months.
Symbols used in this manual
Visual inspection
Refer to an other manual
Use a tool / instrument
Useful hint / tip
Caution - Pay special attention – be careful
Before touching any electrical connections, terminals, ….. make sure by
an instrument that no power is present !
Drawing to refer to (see annex)
!
To Next Page
Loading...