RIGOL
© 2006 RIGOL Technologies, Inc
User’s Guide for DG2000 Series
4-2
If user wants to reset the instrument to the default setting, the system will prompt this
message, to confirm the operation and avoid accidental mistake.
All settings are restored to factory defaults:
When all the settings of the instrument have been reset to the default state, this
message will prompt to inform the user.
Storing waveform, please wait...
Inform the user that the saving operation is in process.
Waveform has been stored as required.
Save the waveform to the specific position according to the user request. Once the
waveform is saved, this message prompts.
Performing Self-Test, Please wait...
When the Self-Test is performing, this message will prompt to inform the user to wait
for a momemt.
Self-Test Passed.
When the Self-Test is finished, the result will be reported to the user. If the Self-test
has been passed, this message will prompt.
The instrument now is UNSECURED.
Inform the user that the password is correct and the user can calibrate the instrument
now. The instrument is unsecured.
Instrument triggered.
The manual trigger mode is activated, and the expected burst or sweep will generate.
Selected modulating arb is **：
Inform the user of the information about the selected modulating waveform.
Calibration Count＝0，Reversion＝04040109：
Inform the user of the Calibration times and the version. Before the instrument is
shipped, it has already been calibrated. When you power a new instrument, the
default calibration times is 0. The latest version can be get at the company’s website:
http://
www.rigol.com.
Calibrating, Please wait...
In the Calibration menu, inform the user to wait when the instrument is preparing to
calibrate.
File doesn't exist!
When deleting the file, to inform the user that the file does not exist.
Complete. Waveform setting have been changed:
Inform the user that the file has been recalled and display the set waveform.
Complete. Waveform data have been changed:
Inform the user that the file has been recalled and display the set arbitrary waveform’s
data.
To Next Page
Loading...
Need help?
General
