RIGOL
© 2006 RIGOL Technologies, Inc
User’s Guide for DG2000 Series
4-9
frequency is changed to 30 MHz, the Duty Cycle will be changed to 50%.
For a frequency less than 8 MHz, the Duty Cycle range is 20% to 80%.
For a frequency between 8MHz and 16 MHz, the Duty Cycle range is 40% to 60% ;
For a frequency greater than 16 MHz, the Duty Cycle is 50%.
Other parameters were modified.
For the Pulse Waveform, the generator will adjust the following parameters
automatically in the order below to generate the pulse waveform: Edge time- Pulse
Width-Period. When the period changes, the Edge Time and Pulse Width will also
change according to the period.
Burst type has been changed to N-Cycle.
When the Trigger Source is turn from External/ Manual to Internal, the Burst Mode
should be changed to N-Cycle.
Sorry, unable to burst DC.
The generator can not use DC Voltage function to generate Burst.
Burst has been turned off to allow DC.
The generator can not use DC to generate Burst. So the Burst is turned off.
To Next Page
Loading...
Need help?
General
