Chapter 11 Remote Control RIGOL
DG4000 User's Guide
Chapter 11 Remote Control
DG4000 can be controlled remotely through the following two methods.
User-defined programming
Users can program and control DG4000 by using the SCPI (Standard Commands
for Programmable Instruments) commands. For more information about the
commands and programming, refer to the
DG4000 Programming Guide
.
Use PC software
Users can use the PC software to send commands to remotely control DG4000.
Ultra Sigma of RIGOL is recommended. You can download the latest version of
Ultra Sigma from RIGOL official website (
www.rigol.com).
DG4000 can communicate with PC through USB and LAN instrument buses. This
chapter will give a detailed introduction of how to use Ultra Sigma to control
DG4000 remotely through various interfaces.
Subjects in this chapter:
Remote Control via USB
Remote Control via LAN
To Next Page
Loading...
