RIGOL Chapter 2 Basic Waveform Output
DG4000 User's Guide
To Set the Duty Cycle
Duty Cycle is defined as the percentage that the high level takes up in the whole
period as shown in the figure below.
The duty cycle range is limited by the "Freq/Period" setting. Please refer to
"Signal Characteristics" in "Specifications". The default value is 50%.
Press Duty Cycle to highlight the softkey. At this point, use the numeric keyboard
to input the duty cycle value and select the unit "%" from the pop-up unit menu or
use the direction keys and knob to modify the current value. For the input method
of duty cycle value, refer to the introduction in "
Parameter Setting Method".
To Next Page
Loading...
