RIGOL Chapter 3 Arbitrary Waveform Output
DG4000 User's Guide
Point By Point Output Mode
DG4000 supports point by point output of arbitrary waveform. Press Arb to open
the arbitrary waveform setting menu and press Point By Point to enable the
point by point output mode of arbitrary waveform.
In point by point output mode, the generator calculates the frequency
(30.517578125kHz) of the output signal automatically according to the wave table
length (16,384) and sample rate. The generator outputs waveform points one by
one at this fixed frequency. Point by point output mode can prevent the loss of
important waveform points.
To Next Page
Loading...
