RIGOL Chapter 2 Front Panel Operations
2-80 DG800 User's Guide
is set to "Ram Data"), and its available choices include "Head Pos", "Trig Pos",
and "Tail Pos".
Tap or use the knob to select the channel to be read, and then set the
parameters of the corresponding channel. Tap Read. At this time, DS1 will enter
the "Stop" status automatically, and DG800 will read the arbitrary waveform
data (i.g. the waveform data collected by DS1) automatically. After reading the
data, the instrument saves them to the internal RAM of the current channel and
switches to Sequence mode (if the current mode is not Sequence mode)
automatically.
4. Use the BNC cable to connect the output of the current channel of DG800 to the
input of DS2. Turn on the channel output and DG800 will output the arbitrary
waveform collected by DS1. You can observe the waveform collected by DS1
from DS2 by setting DS2.
To Next Page
Loading...
