Rigol DG800 Series - User Interface

RIGOL Chapter 1 Quick Guide
1-12 DG800 User's Guide
User Interface
The DG800 user interface is shown in the following figure.
Figure 1-1 User Interface
1. Channel Output Configuration Status Bar
Displays the current output configuration of the channel.
Note: Two channels can be enabled simultaneously, but you cannot select both
channels at the same time.
Output Impedance Type:
High impedance: displays HighZ.
Load: displays impedance (the
default is 50 Ω and the range is
from 1 Ω to 10 kΩ).
Channel Output State:
ON: illuminated in yellow.
OFF: grayed out.
Selected Waveform:
Sine/Square/Ramp/Pulse/Noise/Prbs/Dualtone/Harm
/Rs232/DC/Arb/Sequence
Modulation Type: AM/FM/PM/ASK/FSK/PSK/PWM
Sweep Type: Linear/Log/Step
Burst Type: Ncycle/Infinite/Gated
1 2 3
7 6 5 4
8
9
10
11