Rigol DG800 Series - Channel Copy

RIGOL Chapter 2 Front Panel Operations
2-102 DG800 User's Guide
Coupling
DC
High Freq Rejection
Off
System Parameter
System Setting
Language*
Determined by Factory Delivery Setting
Power-on
Default
Clk Source
Internal
Beeper
On
Decimal
Dot
Delimiter
Comma
System Log
Off
DispSet
Screen Saver
Off
Brightness*
100
Print Setting
Location
USB Storage Device
Format*
PNG
Interface
GPIB*
2
DHCP*
On (default setting in LAN)
Auto IP*
On (default setting in LAN)
Manual IP*
Off (default setting in LAN)
Channel Copy
DG800 supports states and waveform copy function between its two channels, i.g.
copying all parameters and states (except the channel output state), as well as the
arbitrary waveform data of one channel to the other one.
Modify the channel setting of CH1, and then tap at the lower-right corner of the
user interface to copy all parameters and states (except the channel output state), as
well as the arbitrary waveform data of CH1 to CH2.
Modify the channel setting of CH2, and then tap at the lower-right corner of the
user interface to copy all parameters and states (except the channel output state), as
well as the arbitrary waveform data of CH2 to CH1.