Rigol DM3068

Chapter 1 Specifications RIGOL
Service Guide for DM3068
1-3
[4] The basic DC accuracy specifications include RMS noise at 100 NPLC. For <100 NPLC, add “
RMS Noise Adder
” to the basic DC accuracy
specifications.
SFDR & SINAD
[1]
Function
Range
Spurious-Free Dynamic Range (SFDR)
Signal-to-Noise-and-Distortion (SINAD)
DCV
200mV
81
76
2V
79
78
20V
79
75
200V
83
80
1000V
86
82
DCI
200uA
89
69
2mA
86
81
20mA
88
69
200mA
81
79
2A
69
64
[1]
Typical value. -1dBFS, 1kHz single tone. 100us aperture time, zero trigger delay, auto zero off and 4096 samples.
Measuring Characteristics
DC Voltage
Input Resistance
200mV, 2V, 20V ranges: Selectable 10MΩ or >10GΩ
(For these ranges, input beyond ±26V are clamped through 106kΩ (typical) )
200V and 1000V ranges: 10MΩ±1%
Input Protection
1000V
Input Offset Current
50pA, at 25
℃
, typical
CMRR (common mode
rejection ratio)
140dB for 1 kΩ unbalance in LO lead, ±500VDC peak maximum.
Resistance
Measurement Method
Selectable 4-wire or 2-wire resistance
Current source referenced to LO input
Open-circuit Voltage
Limited to <10V
Max. Lead Resistance
(4-wire)
10% of range per lead for 200 Ω, 2 kΩ ranges, 1 kΩ per lead on all other ranges