RIGOL Chapter 1 Specifications
Service Guide for DM3068
Available on 200Ω, 2kΩ and 20 kΩ ranges.
Externally accessible 500mA, 250V fast blow fuse at the rear panel for 200uA, 2mA, 20mA and 200mA ranges.
Internal 10A, 250 V slow blow fuse for 2A and 10A ranges.
300 samples/sec, with audible tone
Adjustable from 1 Ω to 2000 Ω
Autozero OFF Operation (typical value)
Following instrument warm-up at the environment temperature ±1
℃
and <5 minutes, add 0.0001 % range + 2 uV for DCV and 2 mΩ for resistance.
Settling Time Considerations
Reading settling times are affected by source impedance, cable dielectric characteristics and input signal changes. The default measurement delay is selected
to give first reading right for most measurements.
Measurement Considerations
Telon or other high-impedance, low-dielectric absorption wire insulation is recommended for these measurements.
To Next Page
Loading...
