Rigol DS1000 Series - Page 12

RIGOL
© 2008 RIGOL Technologies, Inc.
Programming Guide for DS1000/DS1000CA Series
2-4
4. :AUTO
Command Format:
:AUTO
Explanation:
The command controls the oscilloscope to evaluate all input waveforms characteristics and
set the optimum conditions to display the waveforms.
5. :FORCetrig
Command Format:
:FORCetrig
Explanation:
The command forces the oscilloscope to display a steady waveform when there is
no suitable trigger condition. The usual trigger modes are “Normal” and “Single”.
6. :Trig%50
Command Format:
:Trig%50
Explanation:
The command sets the trigger level to the vertical middle of the signal amplitude.
7. :HARDcopy
Command Format:
:HARDcopy
Explanation:
The command is to extract the current information on the screen.
8. :INFO:LANGuage
Command Format: