RIGOL
© 2006 RIGOL Technologies, Inc.
User‟s Guide for DS1000 Series
To Use Digital Leads (DS1000xD)
1. Switch off power supply of the Device Under Test if necessary to avoid short circuit.
Since no voltage is applied to the leads at this step, you may keep the oscilloscope
on.
2. Connect one end of the flat cable FC1868 to the Logic Analyzer Input, connect the
other end to Logic Head LH1116. An identifier is located on each end of the flat
cable, it can only be connected in one way. It is unnecessary to switch off power
supply of your oscilloscope connect the cable.
Figure 1-10
Digital Channel Interface
CAUTION: Use only FC1868, LH1116, TC1100 and LC1150 made by
RIGOL for specified DS1000xDs.
To Next Page
Loading...
Need help?
General
