Rigol DS1000CA Series - Command Abbreviation

Programming Introduction RIGOL
Programming Guide for DS1000CA Series
1-5
Command Abbreviation
All the commands of DS1000CA series are case-sensitive, so you can use any kind
of them. As some commands are too long to memory and spell, we set the
abbreviation for the commands in order to reduce your work and memory difficulty.
Note that if use abbreviation, the capital letters specified in commands must be
written completely.
For example:
:TRIGger:EDGE:SLOPe
can be entered as:
:TRIG:EDGE:SLOP