Rigol DS1000CA Series - Display Commands

Programming Introduction RIGOL
Programming Guide for DS1000CA Series
2-9
DISPlay Commands
DISPlay Commands are used to adjust the display mode of oscilloscopes.
Display Commands include:
 :DISPlay:TYPE
 :DISPlay:GRID
 :DISPlay:PERSist
 :DISPlay:MNUDisplay
 :DISPlay:MNUStatus
 :DISPlay:CLEar
 :DISPlay:BRIGhtness
 :DISPlay:INTensity
 :DISPlay:SCReen
The detailed information of each command are given as follows: