Rigol DS1000CA Series - Page 22

RIGOL Programming Introduction
Programming Guide for DS1000CA Series
2-10
1. :DISPlay:TYPE
Command Format:
:DISPlay:TYPE <type>
:DISPlay:TYPE?
Function Explanation:
The commands are used to set and query the display type between sampling
points. The options of <type> are “VECTors” ( vectir display) or “DOTS” (point
display).
Returned Format:
Query returns “VECTORS” or “DOTS”.
Example:
:DISP:TYPE VECT Set the display type as “VECTors”
:DISP:TYPE? Query returns “VECTORS”
2. :DISPlay:GRID
Command Format:
:DISPlay:GRID <grid>
:DISPlay:GRID?
Function Explanation:
The commands are used to set and query the display grid. The options of
<grid> are “FULL” (set the grid and coordinate on), “HALF” (set the grid on)
or “NONE” (set the grid and coordinate off).
Returned Format:
Query returns “FULL”, “HALF” or “NONE”.
Example:
:DISP:GRID FULL Set the grid state as “FULL”
:DISP:GRID? Query returns “FULL”