Rigol DS1000CA Series - Cursor Commands

RIGOL Programming Introduction
Programming Guide for DS1000CA Series
2-78
CURSor Commands
CURSor Commands are used to set cursor parameters and measure screen datum
by manual, track or automatical mode.
CURSor Commands include:
 :CURSor:MODE
 :CURSor:MANUal:TYPE
 :CURSor:MANUal:SOURce
 :CURSor:MANUal:CURAX
 :CURSor:MANUal:CURAY
 :CURSor:MANUal:CURBX
 :CURSor:MANUal:CURBY
 :CURSor:TRACk:SOURceA
 :CURSor:TRACk:SOURceB
 :CURSor:TRACk:CURA
 :CURSor:TRACk:CURB
 :CURSor:TRACk:CURAY?
 :CURSor:TRACk:CURBY?
The detailed information of each command are given as follows: