Rigol DS1000CA Series - Page 89

Programming Introduction RIGOL
Programming Guide for DS1000CA Series
2-77
39. :KEY:PROMPT_V_POS
Command Format:
:KEY:PROMPT_V_POS
Function Explanation:
This command is used to reset the vertical display of the waveform to the zero
point.
40. :KEY:PROMPT_H_POS
Command Format:
:KEY:PROMPT_H_POS
Function Explanation:
This command is used to adjust the trigger offset (or the delayed scan offset)
to the horizontal zero point.
41. :KEY:PROMPT_TRIG_LVL
Command Format:
:KEY:PROMPT_TRIG_LVL
Function Explanation:
This command is used to adjust the trigger level to the central position of the
screen.
42. :KEY:OFF
Command Format:
:KEY:OFF
Function Explanation:
This command is used to turn off CH1, CH2, MATH and REF keys one by one.