Rigol DS1000CA Series - Page 88

RIGOL Programming Introduction
Programming Guide for DS1000CA Series
2-76
35. :KEY:PROMPT_H
Command Format:
:KEY:PROMPT_H
Function Explanation:
This command is used to set the on-state for delayed scan function.
Repeating the command would make the delay switched between ON and
OFF.
36. :KEY:FUNCtion
Command Format:
:KEY:FUNCtion
Function Explanation:
This command is used to press the multi-function knob.
37. :KEY:+FUNCtion
Command Format:
:KEY:+FUNCtion
Function Explanation:
This command is used to increase the offset of the multi-function knob.
(Equivalent turning the knob clockwise)
38. :KEY:-FUNCtion
Command Format:
:KEY:-FUNCtion
Function Explanation:
This command is used to decrease the offset of the multi-function knob.
(Equivalent turning the knob anti-clockwise)