Rigol DS1000CA Series Programming Guide

RIGOL Programming Introduction
Programming Guide for DS1000CA Series
1-2
Communication Interfaces
Computers communicate with the oscilloscope by sending and receiving messages
over an I/O port such as an USB, RS-232 port or GPIB. Commands appear as ASCII
character strings embedded inside the output statements of a “host” language
available on your computer.
Basic operations that you can do with a computer and an oscilloscope include:
 Set up the oscilloscope.
 Make measurements.
 Retrieve data (waveforms or measurements) from the oscilloscope.

Rigol DS1000CA Series Specifications

General

Brand	Rigol
Model	DS1000CA Series
Category	Test Equipment
Language	English