Rigol DS1000CA Series Programming Guide

RIGOL Programming Introduction
Programming Guide for DS1000CA Series
1-6
Parameter Type
The commands contains 5 kinds of parameters, different parameters has different
setting methods.
1. Boolean
The parameter should be “OFF” or “ON”, for example:
:MEASure:TOTal {ON|OFF}
Thereinto, “ON” denotes to trun on (enable) this function and “OFF” denoets
to turn off (disable).
2. Consecutive Integer
The parameter should be a consecutive integer, for example:
:DISPlay:BRIGhtness <ncount>
Thereinto,<ncount> could be an integer between 0 and 32 (including 0 and
32).
3. Consecutive Real Number
The parameters could be any value within effective range and precision
permiting, for example:
:TRIGger:EDGE:SENSitivity <count>
Thereinto, <count> could be a real number between 0.1 and 1(including 0.1
and 1).
4. Discrete
The parameters can only be the cited value, for example:
:ACQuire:AVERages <count>
Thereinto, <count> could be 2, 4, 8, 16, 32, 64, 128, 256.
5. ASCII Character String
The parameter should a combination of ASCII character string, for example:
:TRIGger:MODE <mod>
Thereinto, <mod> could be “EDGE”, ”PULSe”, ”VIDEO”, ”SLOPe” or
“ALTernation”.

Rigol DS1000CA Series Specifications

General

Brand	Rigol
Model	DS1000CA Series
Category	Test Equipment
Language	English