Rigol DS1000CA Series - Page 95

Programming Introduction RIGOL
Programming Guide for DS1000CA Series
2-83
“MATH” or “NONE”.
Returned Format:
Query returns CHANnel1, CHANnel2, MATH or NONE.
Example:
:CURS:TRAC:SOURB CHAN1 Set channel tracked by cursor B as “CHANnel1”
:CURS:TRAC:SOURB? Query returns CHANnel1
10. :CURSor:TRACk:CURA
Command Format:
:CURSor:TRACk:CURA <value>
:CURSor:TRACk:CURA?
Function Explanation:
This command is used to set and query the position of cursor A in track mode.
The range of <value> is 4~297.
Returned Format:
Query returns position of cursor A.
Example:
:CURS:TRAC:CURA 100 Set position of cursor as 100
:CURS:TRAC:CURA? Query returns 100
11. :CURSor:TRACk:CURB
Command Format:
:CURSor:TRACk:CURB <value>
:CURSor:TRACk:CURB?
Function Explanation:
The commands are used to set and query the position of cursor B in track
mode. The range of <value> is 4~297.