Rigol DS1000CA Series - Page 24

RIGOL Programming Introduction
Programming Guide for DS1000CA Series
2-12
:DISPlay:MNUStaus?
Function Explanation:
The commands are used to set and query the menu “ON” or “OFF”.
Returned Format:
Query returns “ON” or “OFF”.
Example:
:DISP:MNUS ON Set the menu “ON”
:DISP:MNUS? Query returns “ON”
6. :DISPlay:CLEar
Command Format:
:DISPlay:CLEar
Explanation:
The command clears the out of date waveforms on the screen during
waveform persist.
7. :DISPlay:BRIGhtness
Command Format:
:DISPlay:BRIGhtness <ncount>
:DISPlay:BRIGhtness?
Function Explanation:
The commands are used to set and query the grid brightness of the display
from 0 and 32.
Returned Format:
Query returns an integer between 0 and 32.
Example:
:DISP:BRIG 10 Set the grid brightness of the display as 10