Rigol DS1000CA Series - Page 25

Programming Introduction RIGOL
Programming Guide for DS1000CA Series
2-13
:DISP:BRIG? Query returns 10
8. :DISPlay:INTensity
Command Format:
:DISPlay:INTensity <count>
:DISPlay:INTensity?
Function Explanation:
The commands are used to set and query the brightness of the waveform
from 0~32.
Returned Format:
Query returns an integer between 0 and 32.
Example:
:DISP:INT 12 Set the brightness of the waveform as 12
:DISP:INT? Query returns 12
9. :DISPlay:SCReen
Command Format:
:DISPlay:SCReen <scr>
:DISPlay:SCReen?
Function Explanation:
The commands are used to set and query the screen display mode. The
options of <scr> are “NORmal” or “INVerted”.
Returned Format:
Query returns “NORMAL” or “INVERTED”.
Example:
:DISP:SCR NORM Set the display mode as “NORmal”
:DISP:SCR? Query returns “NORMAL”