Rigol DS1000CA Series - Page 35

Programming Introduction RIGOL
Programming Guide for DS1000CA Series
2-23
Example:
:TRIG:HOLD 0.0001 Set the time of holdoff as 100 us
:TRIG:HOLD? Query returns 1.000e-04
7. :TRIGger:STATus?
Command Format:
:TRIGger:STATus?
Function Explanation:
The commands are used to query the current status of the oscilloscope. The
status may be RUN, STOP, T‟D, WAIT, SCAN or AUTO.
Returned Format:
Query returns RUN, STOP, T‟D, WAIT or AUTO.
8. :Trig%50
Command Format:
:Trig%50
Function Explanation:
The command sets the trigger level to the vertical middle of the signal amplitude.
9. :FORCetrig
Command Format:
:FORCetrig
Function Explanation:
The command forces the oscilloscope to display a steady waveform when
there is no suitable trigger condition, which is usually used in “Normal” and
“Single” trigger mode.