Rigol DS1000CA Series - Page 43

Programming Introduction RIGOL
Programming Guide for DS1000CA Series
2-31
3. :TRIGger:SLOPe:MODE
Command Format:
:TRIGger:SLOPe:MODE <mode>
:TRIGger: SLOPe: MODE?
Function Explanation:
The commands are used to set and query the slope condition. The options of
<mode> are “+GREaterthan”, “+LESSthan”, “+EQUal”, “-GREaterthan”,
“-LESSthan” or “-EQUal”.
Returned Format:
Query returns “+GREATER THAN”, “+LESS THAN”, “+EQUAL”, “-GREATER
THAN”, “-LESS THAN” or “-EQUAL”.
Example:
:TRIG:SLOP:MODE +GRE Set the slope condition as “+Greaterthan”
:TRIG:SLOP:MODE? Query Returns “+GREATER THAN”
4. :TRIGger:SLOPe:WINDow
Command Format:
:TRIGger:SLOPe:WINDow <count>
:TRIGger:SLOPe:WINDow?
Function Explanation:
The commands are used to set and query the trigger level of the vertical
window.
The options of <count> are “PA”, “PB” or “PAB” when slope condition is
“+GREaterthan”, “+LESSthan” or “+EQUal”;
The options of <count> are “NA”, “NB” or “NAB” when slope condition is
“-GREaterthan”, “-LESSthan” or “-EQUal”;
Returned Format:
Query returns “P_WIN_A”, “P_WIN_B”, “P_WIN_AB”, “N_WIN_A”, “N_WIN_B”
or “N_WIN_AB”.