Chapter 3 Programming Demos RIGOL
DS1000Z Programming Guide 3-3
Excel Programming Demo
The program used in this demo: Microsoft Excel 2010
The function realized in this demo: send the *IDN? Command to read the device information.
1. Create a new Excel file that enables the Macros. In this demo, the file is named as
DS1000Z_Demo_Excel.xlsm.
2. Run the DS1000Z_Demo_Excel.xlsm file. Click FileOptions at the upper-left corner of the Excel file
to open the interface as shown in the figure below. Click Customize Ribbon at the right, check
Developer and click OK. At this point, the Excel menu bar displays the Developer menu.
To Next Page
Loading...
