Rigol DS1104Z Plus User Manual

RIGOL Chapter 13 Signal Source
13-4 MSO1000Z/DS1000Z User’s Guide
To Output Ramp
Press Src1Conf to open the waveform setting menu. Press Wave and select
"Ramp". At this point, you can set the ramp parameters. For the detailed setting
method, refer to the introduction in "
To Output Sine". This section only introduces
"Symmetry".
Symmetry is defined as the percentage that the rising period of the ramp takes up in
the whole period.
T
t
Symmetry=t/T*100%
Figure 13-1 Symmetry Definition
Press Symmetry to set the symmetry of the ramp waveform. For the setting method,
please refer to the introduction in "
Parameter Setting Method". The range is from
0% to 100%.
www.GlobalTestSupply.com
Find Quality Products Online at: sales@GlobalTestSupply.com

Rigol DS1104Z Plus Specifications

General

Bandwidth	100 MHz
Channels	4
Sample Rate	1 GSa/s
Memory Depth	24 Mpts
Waveform Capture Rate	30, 000 wfms/s
Vertical Sensitivity	1 mV/div to 10 V/div
Timebase Range	5 ns/div to 50 s/div
Connectivity	USB Host, USB Device, LAN, AUX
Vertical Resolution	8 bits
Power Supply	100-240 V AC, 45-440 Hz
Display	7 inch TFT LCD
Trigger Types	Edge, Pulse, Video, Slope
Input Impedance	1 MΩ ± 2%