Rigol DS1104Z Plus User Manual

RIGOL Chapter 14 Store and Recall
14-8 MSO1000Z/DS1000Z User’s Guide
To Create a New File or Folder
This operation is only valid in external storage. Before using external disk, make sure
that a USB storage device (FAT32 format, flash memory) is connected correctly.
First, press Storage  DiskManage and use to select and open the external
disk ("Disk D"). Then, select the desired directory under which you need to create a
new file or folder. The default is the root directory of the USB storage device. Finally,
select the desired file type and press New File or press New Folder directly to turn
on the interface as shown in the figure below.
Figure 14-2 To Create a New File or Folder
This oscilloscope supports Chinese/English input method. The file name or folder
name can contain letters, numbers, underscores, spaces and Chinese characters and
the length of the characters is limited to 31 bytes. The following part introduces how
to input a file name or folder name using Chinese/English input method.
Operation Tip
During the name input, use the menu softkeys to select different operation areas,
then turn
to select the desired content and press down to input the
content selected.
www.GlobalTestSupply.com
Find Quality Products Online at: sales@GlobalTestSupply.com

Rigol DS1104Z Plus Specifications

General

Bandwidth	100 MHz
Channels	4
Sample Rate	1 GSa/s
Memory Depth	24 Mpts
Waveform Capture Rate	30, 000 wfms/s
Vertical Sensitivity	1 mV/div to 10 V/div
Timebase Range	5 ns/div to 50 s/div
Connectivity	USB Host, USB Device, LAN, AUX
Vertical Resolution	8 bits
Power Supply	100-240 V AC, 45-440 Hz
Display	7 inch TFT LCD
Trigger Types	Edge, Pulse, Video, Slope
Input Impedance	1 MΩ ± 2%