Rigol DS1104Z Manual

RIGOL Chapter 1 Disassemble and Assemble
1-12 MSO1000Z/DS1000Z Service Guide
and take off the shield cover gently.
(4) Remove the screw (③) fixing the signal source board using the 5mm
hexagon socket, and take off the signal source board gently.
(5) Remove the screw (②) fixing the main board and front metal plate using
the 5mm hexagon socket.
(6) Remove the 9 screws (①) fixing the main board and front metal plate using
the screwdriver (T10).
(7) Take off the main board gently.
2. To Disassemble the Main Board of MSO1000Z/DS1000Z
Part Explanation:
① 10 screws (torx pan head screw assembly M3*6) fixing the main board and
front metal plate (please remove them according to their actual positions).
Disassemble Steps:
(1) Remove the 4 nuts and washers at the BNC ports on the front metal plate
using the BNC socket.
(2) Remove the 10 screws (①) fixing the main board and front metal plate
using the screwdriver (T10).
(3) Take off the main board gently.

Rigol DS1104Z Specifications

General

Bandwidth	100 MHz
Channels	4
Sample Rate	1 GSa/s
Waveform Capture Rate	30, 000 wfms/s
Vertical Sensitivity	1 mV/div to 10 V/div
Time Base Range	5 ns/div to 50 s/div
Vertical Resolution	8 bits
Interface	USB Host, USB Device, LAN, AUX
Display	7 inch TFT LCD (800 x 480)
Trigger Types	Edge, Pulse, Video, Slope
Power Supply	100-240 V, 45-440 Hz
Memory Depth	24 Mpts (Single Channel), 12 Mpts (Dual Channel)