Linear operation guide: 13562-B 02-19 | 13
Abnormal ame pattern
Each Rinnai ame re has a distinct ame pattern, refer images below. This should look the same
every time you start your re, after an initial warm up period of approximately 20 minutes.
Abnormal ame performance and/or pattern can indicate a problem with your re, such as blocked
gas injectors, or shifting of burn media. There are some warning signs that could indicate a
problem:
- Unusual smell from the appliance
- Continued difculty or delay in establishing a ame
- Either very short or very long ames
- Flame only burns part way across the burner
- Severe soot building up on the inside of the glass
1
.
If any of the above signs occur, please contact Rinnai.
1
Appliances incorporating a live fuel effect, and designed to operate with luminous ames, may exhibit slight carbon
deposits—this is normal.
Your ame pattern should look like this (may vary slightly depending on gas type)
Linear 800 Flametech log set Linear 800 standard log set
Linear 1000 log set
Linear 1000 modern media (glass)
Linear 1500 log set
Linear 1500 modern media not
shown, ame pattern will be the
same as the 1000 model shown
here
To Next Page
Loading...
