Rinnai Linear Series User Manual

14 | Linear operation guide: 13562-B 02-19
Error codes
The Linear has self diagnostic electronics that monitor the appliance during start up and operation.
Should a fault occur the heater will shut down. The fault that has caused the shut down will be
indicated, via the Wi-Fi app on your smart device.
Error
code
Likely cause Suggested solution
00
Mains power failure Reset the re, press the On/Off button on the control
panel, remote control, or app twice, to turn the re
back on.
11
Ignition failure Check the gas supply is turned on. Turn the heater
OFF then ON again. If the problem continues a
service call will be required.
12
Incomplete combustion As above.
14
Overheat safety device Filter may be blocked—service call.
16
Room overheat Lower room temperature to below 40 °C.
31
Room temperature sensor faulty Service call.
32
Overheat temperature 1 sensor faulty Service call.
33
Overheat temperature 2 sensor faulty Service call.
53
Spark sensor faulty Service call.
61
Combustion fan motor faulty Service call.
70
Model error Incorrect PCB for model, service call.
71
Solenoids faulty Service call.
72
Flame detection circuit fault Service call.
73
Communication error Service call.
90
Communication error detected
between the main PCB and Wi-Fi
module
Reset the Wi-Fi module in the re.
91
Communication error detected
between Smart device and Wi-Fi
module
Check your Wi-Fi and Rinnai Wi-Fi module are
within range. Check network settings.

Rinnai Linear Series Specifications

General

Brand	Rinnai
Model	Linear Series
Category	Indoor Fireplace
Language	English