22 | Linear operation guide: 13562-B 02-19
Appendix 1
Glass cleaning
The inside of the glass, over a period of time, may develop some buildup and condensation marks.
These can be removed using a soft microbre cloth, never use solvents or abrasive chemicals.
Do not attempt to clean the glass while the Linear is operating or is still hot. Before starting
make sure the power to the re is off and the glass is cool to touch.
If you are attempting to clean the larger Linear units (1000, 1500), make sure you have an extra
pair of hands available to help lift the glass out.
The glass front sits in a narrow channel at the bottom of the re and is held in place by glass latches
positioned at the top, on either side of the unit (the 1500 model has an extra glass latch in the
center).
WARNING
Glass retainer latch
Louvre
Glass frame tabs
Push up the latch and to the
side to release the glass
To Next Page
Loading...
