Operator Manual Rev 2.00
Page 20 AXLE-612-200
Function Key Navigation
F1 Short – TRUCK SELECT (see page 10)
F1 Long – TRUCK CONFIGURE (see page 11)
F2 Short – REPRINT (see page 12)
F2 Long – CONFIG MENU (see below)
F3 Short – FARM SELECT (see page 11)
F3 Long – CLEAR SELECT
4.4 F2 Configuration Menu:
DISCARD: Time allowing for Truck ID after weighment has taken place.
(default 10 sec)
The Discard option holds the weight data to allow selection of truck after
weighing. This can be useful for applications where the truck reaches
the controller after weighing across the axleWEIGHr scale.
TIMEOUT: Time in between axles before controller times out
and completes axle captures. (default 20 sec)
DYN.SCL: Dynamic scaling factor for “in-motion” calibration adjust. (see
page 6)
ZERO: Zero calibration capture. (do not use)
SPAN: Span calibration capture. (do not use)
MVV: Raw millivolt reading from scale base.
( example .2234 +/- .0001)
VERSION: Menu to display app name and version of application
(Note: to exit the configuration menu either press the clear key or
scroll to quit and press the "OK" key)
To Next Page
Loading...
