Operator Manual Rev 1.21
003X-607-121 Page 11
5.4. Hold
• Press the <HOLD> key to hold the displayed
weight at its current weight.
• The Hold annunciator will be lit.
• Press the <HOLD> key again to release the
weight reading and return the display to normal
weighing.
• All printouts that print the displayed weight will use the
held weight reading if it is currently being displayed. Note:
K307 will not print while a weight is held.
5.5. Peak Hold
• Press the <PEAK> key to show the largest
absolute weight, either positive or negative (eg. -
30 is larger than 25). The instrument compares
the current weight reading with the stored peak
and updates the peak reading whenever a larger
weight is detected.
• The Hold annunciator will be lit.
• Press the <PEAK> key to toggle between the
current weight and the peak weight.
• When displaying the peak weight the Hold
annunciator will be lit.
• When displaying the peak weight, press and hold
the <PEAK> key for two seconds to clear the
peak value and reset back to 0 (zero).
• All printouts that print the displayed weight will use the
held weight reading if it is currently being displayed. Note:
K307 will not print while a weight is held.
To Next Page
Loading...
