Risco LightSYS - Page 11

Mastering Your System
Page 11 LightSYS User Manual
Unset after alarm:
4 chirps (Keyfob)
Confirm
Operation
A one-second tone, if
completed correctly
No sound
No sound
Reject
Operation
Three rapid error
beeps, if incorrect (2,3)
No sound
No sound
Entry Delay
Countdown
Slowly repeating tones
until the entry delay
time period expires (2)
No sound
No sound
Exit Delay
Countdown
Slowly repeating tones
until the exit delay
time period expires (2)
No sound
No sound
Chime Sound
2 second buzzer beep (4)
No sound
No sound
Notes:
1. Based on decisions made at the time your alarm system installation, keypads
may beep during this type of alarm.
2. Keypad beeps may be disabled at the user's discretion, see Buzzer On/Off,
page 39.
3. Press for two seconds to stop the fault beeps
4. Any intrusion zone, if selected for the chime feature, will, when violated
during the unset period, cause the keypad to annunciate the event. The chime
can also be disabled when not required.