Risco LightSYS - System Tones

Mastering Your System
LightSYS User Manual Page 10
If your system has two or three partitions, the LCD displays the system name, date, time
and the status of each partition. A status letter represents the partition’s status, as follows:
AR: Partition Set
NR: Partition Not Ready
AL: Partition in Alarm
HO: Partition Part Set
R: Partition Ready
LCD Blank Display
If defined by your engineer, two minutes after the last keypad operation the keypad will
be disabled and the following display will appear on the LCD:
Enter code:
To release the keypad and return to normal operation mode press: [CODE] + .
Note:
During blank display mode the Ready LED indicates a fault in the system.
System Tones
In addition to the visual indications provided by your keypad(s), your system is designed
to produce audible annunciation after certain events. Depending on the circumstance, such
sounds may be made by your system's keypad(s) or sounders (for example, a sounder or
bell).
Note:
If defined by your engineer, internal bell annunciation can be generated to
accompany any of the keypad sounds.
Event
Keypad Sound
Internal Bell
External
Sounder
Intrusion
Alarm
Rapid beeping
Rapid beeping
Rapid beeping
Fire Alarm
Rapid beeping
Rapid beeping
YES (staggered)
Keypad Police
Emergency
No sound (1)
No sound (1)
No sound (1)
Keypad
Emergency /
Medical
A momentary bleep
No sound
No sound
Setting or
Unsetting
No Sound
System is set:
1 chirp
System is unset:
2 chirps (Keyfob)
System is set:
1 chirp