Risco LightSYS - SMS Operation

LightSYS User Manual Page 48
Appendix D – SMS Operation
The LightSYS enables you to perform remote control operations using simple SMS
commands. The following section describes the SMS commands and the response of the
system to these commands.
Note: This application is available only if a GSM/GPRS module is installed in your system.
Operation
SMS Message Structure
Example
Full Set
[Code] S
1234S
Part Set
[Code] P
1234P
Group Set
[Code][G][Select a one Group
A/B/C/D])
1234GA
Full unset
[Code] US
1234US
Set by partition
[Code] S [Partition No.]
1234S1
Part Partition Set
[Code] P [Partition No.]
1234P1
Group Set by
Partition
[Code] G [Select one Group A/B/C/D]
[Select partitions]
1234GA1
Unset by Partition
[Code] US [Partition No.]
1234US1
Omit a zone
[Code] OM [zone number]
1234OM05
Un-omit a zone
[Code] UNOM [zone No.]
1234UNOM05
Activate Output
[Code] POON [PO No.]
1234POON1
Deactivate Output
[Code] POOFF [PO No.]
1234POOFF1
Change FM
number
[Code] FMPHONE [FM serial number]
NEW [New Phone No.)
1234FMPHONE 3
NEW0529692345
Get system status
[Code] ST
1234ST
Get last alarm
[Code] AL
1234AL
Get SIM credit level
(for prepaid cards)
[Code] CR
1234CR
Notes: SMS commands are not case sensitive (they can contain both capital, small or mixed letters).
A separator between command words is not required, although it is accepted.
SMS Confirmation Message
A confirmation message following a SMS operation is sent to the user, upon request, by
adding the letters “RP” at the end of the SMS messages listed below.
Example:
1234 A RP - A confirmation message following a setting operation is sent to the user.
Confirmation or Fail operation messages can be assigned to the actions of setting,
unsetting, omitting, activating outputs or changing follow me definitions.