Riso SF5 Series - Setting The Print Conditions

Chapter 2 Working with the Printer Driver
41
Chapter 2 Working with the Printer Driver
41
SettingthePrintConditions
You can set various print conditions over the tabs in the [Properties] dialog box.
To open this dialog box, click [Properties] in the [Print] dialog box.
B
SomePrinterDriversettingsaredisabledbythesettings.
PrinterDriver USBash-via-PrinterDriver
PrinterDriverSettings PrintOnly StorageOnly
1
USBprint
(Manual)
1
USBprint
(Auto
process)
[Advanced] Tab
Copies Enable Disable Disable Enable
Auto-process Enable Disable Disable Enable
[Layout] Tab 180-degree rotation Enable Disable Disable Enable
[Advanced] Tab
Print speed Enable Disable Disable Enable
Print density Enable Disable Disable Enable
High Speed
2
Enable Disable Disable Enable
Ink saving Enable Enable Enable Enable
Interval printing
1
Enable Disable Disable Enable
Program printing
1
Enable Disable Disable Enable
ID print
1
Enable Enable Enable Disable
Activate the Condential mode
after job completes
Enable Disable Disable Enable
Output the data after
initializing printer
Enable Disable Disable Enable
[Option] Tab Job separator Enable Disable Disable Enable
Enable : Printer Driver’s setting is active.
Disable : Printer Driver’s setting is disabled (or cannot be set.) Set with printer’s control panel when printing.
1
Not displayed in the SF5 Series.
2
Not displayed in the SF5x3 Series.