Riso SF5 Series - Unexpected Action; Unable to Specify Settings

Chapter 5 Appendix
87
Chapter 5 Appendix
87
UnexpectedAction
Problem Cause/Condition Action
Your RISO printer repeats
the master-making process
for each copy of the
identical page.
The [Collated] check box is
selected in the [Print] dialog box in
the application software.
Cancel the current print job on your computer
and turn off the main power switch of your
RISO printer. After approximately 10 seconds,
turn it on again. Always cancel the [Collate
Copies] or [Collated] option in the [Print]
dialog box when starting a print job.
Your RISO printer does not
operate as specied in the
[Sorter control] option in the
Printer Driver.
The nishing job specied in
the [Sorter control] option is
not available for the current
combination of your RISO printer
and an optional sorter.
Refer to the dedicated user’s guides of your
RISO printer and the optional sorter.
Original data cannot be
output to the USB Flash
Drive.
Are you using the Printer Driver for
USB Flash Drive?
There are two types of Printer Drivers. To
output to a USB Flash Drive, install the USB
ash-via-Printer Driver. Data cannot be output
to a USB Flash Drive using an ordinary
Printer Driver. (
A
23)
Are you using a USB Flash Drive
formatted for RISO folders?
Create a folder just for RISO les in the USB
Flash Drive. (
A
28)
UnabletoSpecifySettings
Problem Cause/Condition Action
A name cannot be entered
in the dialog box to register
the custom paper size.
The name is too long for the
corresponding eld.
Valid range of the length is 30 characters.
A desired value cannot
be entered in the
corresponding elds to
register the custom paper
size.
The value does not fall within the
range.
Enter the value within the valid ranges into
the relevant elds.
The custom paper size
cannot be registered in the
[RISO...] printer
driver.
The relevant dialog box was not
closed correctly.
Click [OK] on [Environment] tab after closing
the [Custom paper entry] dialog box.
(
A
34)
The specied custom paper
size cannot be selected in
the application
[Custom] is not selected in
the [Paper Size] option in the
[Properties] dialog box of the
Printer Driver.
Select [Custom] in the [Paper Size] option.
[Paper Size: Custom] cannot be
selected in the [Printer Setup]
dialog box in the application
software.
Specify a standard paper size which is larger
than the specied custom one.