8 Configuration
EN
40 Rittal Liquid Cooling Package
Fig. 50: Adjusting the TCP/IP settings
In the TCP/IP Configuration window, change the
device's IP address to an admissible network ad-
dress (fig. 50, item 6).
If necessary, correct the settings for the subnet
mask and the gateway.
Alternatively, activate the setting "Use DHCP" for au-
tomatic IP allocation.
Click on the Save button to change your settings.
Change the network settings of your computer to the
original IP address and subnet mask values.
Disconnect the network cable from your computer.
Using a network cable, connect the device to your
computer via the Ethernet LAN.
8.2.3 Changing the measurement units
The measurement units used may be converted from
"°C" to "°F" and from "litres" to "gallons".
After registering on the Liquid Cooling Package (see
section 8.2.1 "Making the connection"), the Web inter-
face for device operation is displayed.
In the left-hand section of the overview window, click
on the Processing Unit entry and in the right-hand
section, click on the Configuration tab.
In the group box System, click on the Units button.
In the Units Configuration window, under the "Tem-
perature Format" dropdown list, select the entry
"Fahrenheit" if preset to "Celsius", and vice versa.
In the dropdown list "Volume Format", select the en-
try "Gallon" if preset to "Litre", and vice versa.
Click on the Save button to change your settings.
8.2.4 LCP configuration
The basic settings for the Liquid Cooling Package are
defined in a configuration file.
In the left-hand section of the overview window, click
on the Processing Unit entry and in the right-hand
section, click on the Configuration tab.
In the group box System, click on the LCP Config-
uration button.
Note:
If the Save button cannot be clicked, an in-
correct entry has been made. In such cas-
es, check your entries and correct them.
Note:
If you have activated automatic IP alloca-
tion ("Use DHCP" setting is activated), the
IP address of the CMC III PU may be
viewed via the USB interface (see the as-
sembly and operating instructions for the
CMC III PU).
Caution!
Access to the configuration file is only
available to users in the "Admin" user
group.
Changes to the configuration file are for
service purposes only and for setting key
operating parameters, which should only
be carried out by Rittal service personnel.
To Next Page
Loading...
Need help?
General
