2. SETTING
IMCB04-E10
6
3. Press the UP key to change the number to 1.
4. Press the SET key to store the new set value. The display goes to the next parameter.
If the initialize code is set to 1 or 2, enter 1 or 2 in the units digits of the set value (SV)
display unit by pressing UP or DOWN key.
If the set value corresponds to any digit other than the units digit, press the shift key to move
the brightly lit digit. The brightly lit digit moves as follows every time the shift key is
pressed.
Input type selection
0000
000
0
00
1
1
J
L
Input type Set value
R/S
SET
PV
SV
OUT1 ALM1 ALM2OUT2 AT
Engineering unit setting
R/S
SET
PV
SV
OUT1 ALM1 ALM2OUT2AT
List of parameters
To Next Page
Loading...
