RKC INSTRUMENT CB100 - List of Parameters in Initialize Code 2 (Cod=2)

2. SETTING
IMCB04-E10
23
2.5 List of Parameters in Initialize Code 2 (Cod = 2)
Parameters in initialize code 2 are only displayed.
(1) TCJ (Holding peak ambient temperature)
The maximum ambient temperature on the rear terminal board of the instrument is stored and
displayed on the set value (SV) display unit. Displayed when input type is TC input.
Display range: −10 to +100 °C
Display resolution: 1 °C
(2) WTH (Operating time [Upper digits] )
The integrated value (upper 2 digits) of power on time is shown on the set value (SV) display unit.
If the total operating time exceeds 100,000 hours, the integrated operating time is reset.
Display range: 0 to 10 (Operating time from 0 to 100000 hours can be displayed for both the
upper and lower digits.)
Display resolution: 10,000 hours
(3) WTL (Operating time [Lower digits] )
The integrated value (lower 4 digits) of power on time is shown on the set value (SV) display unit.
If the total operating time exceeds 9,999 hours, these digits move to the operating time display unit
[Upper digits] (WTH).
Display range: 0000 to 9999
Display resolution: 1 hour
Example: When the integrated value of operating time equals to 100,000 hours.
The upper 2 digits of 100,000 hours are shown on the operating time display unit [upper digits]
(WTH) and the lower 4 digits are shown on the operating time display unit [lower digits].
Operating time display unit (Upper digits) Operating time display unit (Lower digits)